Paver Base Calculator
Estimate compacted base thickness, ordered aggregate, bedding sand and excavation for a patio or walkway.
Enter your project measurements
Your material estimate
How to use this calculator
A paver patio is only as reliable as the prepared layer below it. This tool works backward from the compacted thickness you plan to install. It separates crushed aggregate from bedding sand and estimates both excavation and buying quantities.
Enter the finished paved area’s length and width, your desired compacted aggregate depth, sand depth and paver thickness. The calculator reports base volume in place, estimated loose aggregate to order, weight in US short tons, sand quantity and theoretical excavation.
The default 4-inch base is an illustration for an ideal pedestrian setting. CMHA notes that residential driveways may require at least 6 inches in ideal conditions, and sites with weak soils, frost or poor drainage often need substantially more.
Formula and calculation methodology
Base in place: paved area × compacted base depth. Convert inches to feet and cubic feet to cubic yards by dividing by 12 and 27, respectively.
Aggregate to order: in-place volume × (1 + user-entered loose-volume factor) × (1 + order allowance). Multiply this loose estimate by the user-entered loose density to estimate tons. Do not treat loose volume and compacted volume as interchangeable.
Sand and excavation: sand is a separate layer. Excavation is paved area × combined compacted base, bedding and paver thickness. It excludes soil over-excavation, edge restraint extensions, slopes and site grading.
Practical planning and common mistakes
- Do not substitute smooth pea gravel or river rock for a standard dense-graded paver base. CMHA specifically warns against round aggregate for this purpose. Select an approved aggregate for the actual pavement system.
- A nominal 1-inch bedding layer is not a way to fix depressions in a poorly graded base. Compact and level the supporting aggregate first, then screed the bedding per the paver manufacturer’s specification.
- Use supplied density, not solid-stone density. Contractors may order tons while the plan specifies installed cubic yards. In-place density, delivered loose density and moisture content affect conversion.
Frequently asked questions
How deep should a paver base be?
For favorable pedestrian conditions CMHA cites at least 4 inches of compacted base; residential driveways may start at 6 inches. These are not universal designs. Climate, soil strength, drainage, loading and local specifications can increase the needed thickness.
Does the calculator include sand?
Yes. Bedding sand is estimated separately from compacted base aggregate. Joint sand, geotextile and edge restraints are not included because their quantities depend on the paving system.
Why is the amount to order larger than the installed volume?
You can enter an extra loose-volume percentage and an order allowance. Their defaults are placeholders, not a guaranteed shrinkage factor. Ask the supplier for delivery density and contractor for compaction guidance.
Research sources and further reading
Technical references: Concrete Masonry & Hardscapes Association (CMHA) base guidance; CMHA bedding-sand installation guidance. Source guidance informs safe defaults or material selection, but no organization endorses our estimates.
More tools: Crushed Stone Calculator · Stone Cost Calculator. See our Calculation Methodology and Disclaimer.
Accuracy note: Results are planning estimates, not a supplier quotation, site survey, structural design, drainage design, or professional engineering advice. Verify dimensions, delivered loose bulk density, material grade and local requirements before ordering.