Riprap Calculator
Estimate quantities for a specified slope face and protective stone layer without guessing hydraulic design.
Enter your project measurements
Your material estimate
How to use this calculator
Riprap is a layer of large stone installed along banks, slopes and other erosion-prone locations. This tool estimates material from a specified area and thickness. It deliberately does not choose safe rock size or design the bank protection system.
The horizontal slope run is not the length of the face. Combine run and vertical rise using the Pythagorean theorem to find the actual sloping distance, then multiply by the bank length and specified layer thickness.
Government riprap guidance evaluates hydraulics, stone gradation, flow, local scour, embankment geometry and toe protection. A simple volume calculator cannot establish those parameters. Use approved design quantities for any safety-critical site.
Formula and calculation methodology
True slope face: square root of (horizontal run squared + vertical rise squared). Multiplying by longitudinal bank length gives a sloped surface area in square feet.
Installed volume: slope face area × designer-specified normal layer thickness in feet. Convert cubic feet into cubic yards by dividing by 27.
Material to order: layer cubic yards × (1 + extra allowance). Estimated tons equal ordered volume times editable bulk density. Geotextile area uses slope face area with a separate user-entered allowance.
Practical planning and common mistakes
- Do not confuse vertical rise with the true width of the slope. A bank with a 10-foot horizontal run and 5-foot vertical rise has an 11.18-foot face, not a 10-foot face.
- Riprap is not selected by aesthetics alone. USACE’s published workflow starts with site hydraulics, rock sizing and gradation, and also considers scour and toe protection.
- Rounding, placement tolerance, access and buried toe quantities can materially change the bill of materials. This calculator excludes buried toe trenches and additional launchable stone. Add engineered components separately.
Frequently asked questions
Does this calculator determine riprap stone size?
No. It estimates volume and weight only from dimensions and thickness supplied by you. Hydraulically appropriate grading requires site data and engineering methods that are outside this calculator.
What is a US short ton?
One US short ton is 2,000 pounds. A metric tonne is 1,000 kilograms, or about 1.1023 US short tons. Confirm which unit appears in supplier quotes.
Does riprap thickness follow the slope?
The input represents the normal thickness of the stone layer on the slope face. Enter the approved layer thickness. Do not substitute a vertical depth reading or estimate thickness from flow speed alone.
Research sources and further reading
Technical references: USACE HEC-RAS riprap and scour design workflow; FHWA HEC-11 design of riprap revetment. Source guidance informs safe defaults or material selection, but no organization endorses our estimates.
More tools: Stone Cubic Yards Calculator · Stone Cost Calculator. See our Calculation Methodology and Disclaimer.
Accuracy note: Results are planning estimates, not a supplier quotation, site survey, structural design, drainage design, or professional engineering advice. Verify dimensions, delivered loose bulk density, material grade and local requirements before ordering.